Lichthupe und Hupe funktioniert nicht

Alles zum jüngsten Spross im Hause

Moderator: gk

get.freaky
Morinisti
Morinisti
Beiträge: 167
Registriert: Sonntag 15. April 2018, 19:36
Wohnort: NDS

Lichthupe und Hupe funktioniert nicht

Beitrag von get.freaky »

Moin,

bis vor kurzem funktionierte beides einwandfrei.

von null auf nix Lichthupe nicht mehr ( Fernlicht aber schon) und Hupe nicht.


Bei Lichthupe zeigt die Kontrollampe im Kombiinstrument an an, geht aber nicht.

Hab so ziemlich alles geprueft. Relais, Verbindungen, Schalter zerlegt und gemessen, und und und....nix zu finden.
Kabelbruch ist auch keiner zu finden.

Bei der Lichthupe koentte ja das Kombi Instrument selbst Schuld sein, aber bei der Hupe....komisch.

Jemand eine Idee?????


Gruß
Oliver
In meinem Herz schlägt es V2

Corsaro 1200 Compatto
get.freaky
Morinisti
Morinisti
Beiträge: 167
Registriert: Sonntag 15. April 2018, 19:36
Wohnort: NDS

Beitrag von get.freaky »

So, Lichthupe ist wieder da.

Lag an der zu geringen Last vom LED Scheinwerfer.......
In meinem Herz schlägt es V2

Corsaro 1200 Compatto
VesaII
Morinisti
Morinisti
Beiträge: 240
Registriert: Dienstag 24. April 2018, 14:36

Beitrag von VesaII »

get.freaky hat geschrieben:So, Lichthupe ist wieder da.

Lag an der zu geringen Last vom LED Scheinwerfer.......
And i was just thinking of getting LED headlight and rear blinkers. Are they possible to use on 9,5 and what kind of tricks are needed? Which brand and type you use?
Br,
Vesa
get.freaky
Morinisti
Morinisti
Beiträge: 167
Registriert: Sonntag 15. April 2018, 19:36
Wohnort: NDS

Beitrag von get.freaky »

LED Headlight must have minimum 10W both channels I think.

Than function is good.

Flasher you need special relais for LED Flasher, cost only 15,- € from Polo or Louis and you need at one position another resistor about 100 Ohm or so, otherwise your dashboard control lamp will not work correct.

When you know both it is no problem.

KR
Oliver
In meinem Herz schlägt es V2

Corsaro 1200 Compatto
VesaII
Morinisti
Morinisti
Beiträge: 240
Registriert: Dienstag 24. April 2018, 14:36

Beitrag von VesaII »

get.freaky hat geschrieben:LED Headlight must have minimum 10W both channels I think.

Than function is good.

Flasher you need special relais for LED Flasher, cost only 15,- € from Polo or Louis and you need at one position another resistor about 100 Ohm or so, otherwise your dashboard control lamp will not work correct.

When you know both it is no problem.

KR
Oliver
Ok, thanks. Winter is coming and hopefully snow too. So it is time to put bike in garage and this LED thing is good to know if inspiration hits.
Br,
Vesa
VesaII
Morinisti
Morinisti
Beiträge: 240
Registriert: Dienstag 24. April 2018, 14:36

Beitrag von VesaII »

VesaII hat geschrieben:
get.freaky hat geschrieben:LED Headlight must have minimum 10W both channels I think.

Than function is good.

Flasher you need special relais for LED Flasher, cost only 15,- € from Polo or Louis and you need at one position another resistor about 100 Ohm or so, otherwise your dashboard control lamp will not work correct.

When you know both it is no problem.

KR
Oliver
Ok, thanks. Winter is coming and hopefully snow too. So it is time to put bike in garage and this LED thing is good to know if inspiration hits.

Hops... Did write on wrong arena about 9.5 http://www.ital-web.de/forum/viewtopic. ... 9129#49129

Hope old Morinis have same size lamp...
Br,
Vesa
get.freaky
Morinisti
Morinisti
Beiträge: 167
Registriert: Sonntag 15. April 2018, 19:36
Wohnort: NDS

Beitrag von get.freaky »

So, da der TÜV vor der Haustür stand, war ich gezwungen das Problem mit der Hupe auch nochmal in Angriff zu nehmen.

Und die Moral von der Geschichte:

Es lag lediglich an den Steckern. Scheinbar durch Witterungseinflüsse so korrodiert das der Widerstand zu groß war. Zu sehen war von aussen nichts, sah alles gut aus.

Also eingfach Kabel 2 cm gekürzt, neue Stecker drauf, da ging es wieder.....

Gruß
Oliver
In meinem Herz schlägt es V2

Corsaro 1200 Compatto
Antworten

Zurück zu „9 1/2 und 1200 Sport“